top a 05
Section word notebook13

Released: Creation Workshop With Resin Profiles v1.0.0.75

Updated Version of Creation Workshop Pre-Configured with Resin Profiles
Designed to make the setup and operation of Creation Workshop easier by including a large selection (and growing!) of pre-configured resin profiles, system and display settings, etc.
Version is still being maintained for compatibility with older systems, but this is the most current version available in the free market.
Included is the walkthrough for setting up your Wanhao D7 for the first time. Notable improvements are memory usage, added configuration options for lift speeds during bottom layer cures, and cosmetic arrangement of parts of the UI.

As new resins come in from other sources, I'll add them to the releases in the form of revisions. New Resin Manufacturer's and ones who didn't make it into this release are welcome to message me about being included in the future releases and are urged to participate on the groups, and in the forums.
Included Resin Profiles @ 100, 50 and 35 Micron Layer Heights, for Wanhao, Monocure, and FTD Resins. (You will still need to dial in as machine UV can differ from one machine to another, but its all close, and been tested on a series of D7's for an average.)
It is available on the D7 Facebook Groups (Oficially Supported on Wanhao D7 DLP Resin printer Support) and the Wanhao Support Forums at
Released: Creation Workshop Pre-Configured With Re...
bottom d 01
girder nav5